If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
I/O Plate removal?
There are two plates on the Enlight 7250 case, one is sheet metal and
the other is thin silver tin one behind it. How do you remove them to replace with the one that came with my P4c800 MOBO? I don't get it, I thought these I/O plates were standardized? It doesn't match any I've seen. On the Enlight plate, the audio jacks run up vertically up. On the MOBO. they run horizontally across. Am I supposed to remove this thicker sheet metal plate and drill it out? The one with the MOBO is flimsy compared to that one. Why are there two plates? |
#3
|
|||
|
|||
jf wrote:
There are two plates on the Enlight 7250 case, one is sheet metal and the other is thin silver tin one behind it. How do you remove them to replace with the one that came with my P4c800 MOBO? I don't get it, I thought these I/O plates were standardized? It doesn't match any I've seen. On the Enlight plate, the audio jacks run up vertically up. On the MOBO. they run horizontally across. Am I supposed to remove this thicker sheet metal plate and drill it out? The one with the MOBO is flimsy compared to that one. Why are there two plates? I doubt the original I/O plate has screws. It's normally a tight friction fit. Push it inward, equal pressure on both sides. Replace it with the I/O panel which came with your motherboard. The outside dimensions will be the same. The original I/O plate is kind of standard. The one which came with the P4C800 will fit it and perhaps a small number of other boards. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Safe PSU removal | kony | General | 3 | May 13th 04 07:40 AM |
Tualatin IHS removal. (Kony) | ~misfit~ | General | 7 | April 7th 04 06:10 AM |
Plate for front USB, firewire ports | Stuart Chapman | General | 3 | April 1st 04 02:58 PM |
P4 standard HSF removal | Ulrich S. | General | 3 | November 5th 03 07:51 AM |
PC Dead since removal of TV Card | amstereofan | General | 3 | July 6th 03 09:15 PM |