If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Help!! The P4v8x-x don't work with atapi device now!!! Why??
I have now the pc of my friends, with a asus p4v8x-x motherboard... It
work fine if ther'is the hard disk master in first ide channel as master, but if i connect one or two cdrom device in the second ide channel, or one in first channel as slave, the pc is very very slow at the boot or fail the boot or is freeze in winxp, or/and dont appear the cdrom units in win xp.... I have tried all, to change cdrom units, power switch, hard disk, cable, restore default values in the bios... nothing. This problem is borned two weeks ago, because in the past all the system worked fine.... is possible that ther'is a hardware fall in the notherboard??!! |
#2
|
|||
|
|||
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PCI modems don't work? | Rivergoat | Asus Motherboards | 6 | April 7th 04 02:18 PM |
Calling any Logitech Dinovo / MX900 owners | Monkeys | General | 1 | April 6th 04 10:56 AM |
DELL upgrade with Kingston Value RAM - will it work properly | stromer | General | 0 | January 31st 04 08:29 AM |
Can't get two CD drives to work on XP machine | Bruce | General | 2 | September 5th 03 01:01 AM |
Hard drive as slave on same cable as ATAPI master? | AJ | Homebuilt PC's | 1 | July 28th 03 11:29 AM |