If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
HP CDRW says Calibration area full
I get error message while trying to burn anything with report that the
"Calibration area is full". This is an old HP 7200 that has not seen many burns or much use. Has anyone had a problem like this and know how to go about fixing? I tried in other computer but same results. I have replaced this drive but don't want to trash it if it is s simple fix. Thanks Proto |
#2
|
|||
|
|||
Proto wrote:
I get error message while trying to burn anything with report that the "Calibration area is full". This is an old HP 7200 that has not seen many burns or much use. Has anyone had a problem like this and know how to go about fixing? I tried in other computer but same results. I have replaced this drive but don't want to trash it if it is s simple fix. Thanks Proto It's a standard problem. It means that your blank is poorly matched to your writer. In this case, it's likely that you are using a disc rated for high speed where the drive is a low-speed. Even if the box says the blank will write at low speed, it may not do it well or, in your case, at all in a specific drive. If all else fails and you don't want to replace your writer, try a DigitalAudio blank. Though the royalty it pays and the smaller market it has will raise its price, at least it must record at 1x, so will handle the low speed of your drive relatively well. Mike -- http://www.mrichter.com/ |
#3
|
|||
|
|||
"Robert Hancock" wrote in message . ca... Likely either the disc is very incompatible with the drive, or the drive is bad (quite likely a weak laser), though it's possible it could be due to dust in the drive (you could try blowing it out with compressed air). The error message means that the drive exhausted all of the PCA (Power Calibration Area) on the disc without finding an appropriate laser power setting for the disc. -- Thanks gents. I guess the drive is finally dead. It's about time I guess. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
my new mobo o/c's great | rockerrock | Overclocking AMD Processors | 9 | June 30th 04 08:17 PM |
Power Calibration error - need new power supply | Anonymous | Homebuilt PC's | 24 | May 10th 04 08:03 PM |
CDRW not being detected as pri or sec slave... | Fredericks | Homebuilt PC's | 3 | April 21st 04 04:52 AM |
CDRW not being detected as pri or sec slave... | Fredericks | General | 2 | April 18th 04 10:01 PM |
My next CDRW High Speed problem | doug | Cdr | 5 | July 29th 03 07:55 PM |