|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
Compaq Presario 5446 into Presario 5440 Case
I'm having trouble with the power button on a second-hand case I've
I am trying to install a Compaq Presario 5446 into a case that's
badged ‘Compaq Presario 5440'
The 5446 motherboard has a 20 pin connector (2 rows of 10). From the
top, pin 5 on the right is missing (19 pin connector!?).
The original power button was plugged at the top on the right, the
wire colours :- empty, Red, Orange, Yellow,blocked,Green, Blue,
The connector on the new case is as follows:- Left row Yellow, White,
the rest empty. Right row Blue, Black, Black, White/Blue stripe.
The only other info I can give is the original 5446 button was screwed
into the chassis (Earthed?) on a small circuit board, whilst the
button on the new case is mounted in a plastic mould. Blue + Black
going to power, White + Yellow HD and Black + White Blue stripe to
Can anyone give any advice!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Happy Birthday America||SST||Ati Videocards||336||November 27th 03 08:54 PM|
|Happy Birthday America||SST||Nvidia Videocards||336||November 27th 03 08:54 PM|
|Compaq Presario hard drive||wazaman59||General||5||September 2nd 03 03:11 PM|
|Cooling Questions||Peter Cavan||General||35||September 2nd 03 06:42 AM|
|Compaq FAQ||HH||Compaq Computers||1||August 7th 03 11:24 PM|