If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
20 Pin ATX Tester
Got a friend selling these pretty cheap, thought I'd pass it along.
BTW, Early on I had a PC die, power seemed OK, but the mother board was dead. Without a thought in the world about the power supply being the cause I replaced the board and it promptly died. My buddy, who sold me the board (new), told me a number of points where I must have screwed up and placing my faith in him I said I'd replace the board (again) but after saying the board may have been bad to start with. Taking this as an insult to his pride, he took the a new board off the self, tested it, installed it and it died. At that point he went looking for the cause and found that the power supply was pumping some odd over voltages on the 5 & 12 volt circuits. Apparently not enough to kill the fan or the HDs, just the mother board. He was some what embarrassed and as a way of joking about it bought both of us pocket sized voltage test meters (still have mine). So in light of a number of recent post about power issues, I offer this. KMC 20 Pin ATX Tester CoolMax 20 pin ATX power supply tester. Quickly isolate and verify power supply failures. Checks all ATX output voltages, +3.3V, -12V, PG, +12V, +5VSB, -5V, and +5V via LED light. Also checks 4 pin peripheral connectors, floppy drive connectors and ATX12V connectors for proper outputs. Very handy and easy to use. Suitable for any ATX power supply with 20 pin mainboard connector. Instructions stamped directly on tester. Retail packed. Availability: Usually ships the same business day 20-pin-atx-tester price: $9 |
#2
|
|||
|
|||
20 Pin ATX Tester
"Kevin Childers" wrote in message
... Got a friend selling these pretty cheap, thought I'd pass it along. BTW, Early on I had a PC die, power seemed OK, but the mother board was dead. Without a thought in the world about the power supply being the cause I replaced the board and it promptly died. My buddy, who sold me the board (new), told me a number of points where I must have screwed up and placing my faith in him I said I'd replace the board (again) but after saying the board may have been bad to start with. Taking this as an insult to his pride, he took the a new board off the self, tested it, installed it and it died. At that point he went looking for the cause and found that the power supply was pumping some odd over voltages on the 5 & 12 volt circuits. Apparently not enough to kill the fan or the HDs, just the mother board. He was some what embarrassed and as a way of joking about it bought both of us pocket sized voltage test meters (still have mine). So in light of a number of recent post about power issues, I offer this. KMC 20 Pin ATX Tester CoolMax 20 pin ATX power supply tester. Quickly isolate and verify power supply failures. Checks all ATX output voltages, +3.3V, -12V, PG, +12V, +5VSB, -5V, and +5V via LED light. Also checks 4 pin peripheral connectors, floppy drive connectors and ATX12V connectors for proper outputs. Very handy and easy to use. Suitable for any ATX power supply with 20 pin mainboard connector. Instructions stamped directly on tester. Retail packed. Availability: Usually ships the same business day 20-pin-atx-tester price: $9 There is like 1 to 100,000 chance you will ever benefit from such a device. -- Bill 2 Gateway MX6124 - Windows XP SP2 3 Asus EEE PC 701G4 ~ 2GB RAM ~ 16GB-SDHC 2 Asus EEE PC 702G8 ~ 1GB RAM ~ 16GB-SDHC Windows XP SP2 ~ Xandros Linux |
#3
|
|||
|
|||
20 Pin ATX Tester
"BillW50" wrote in message ... "Kevin Childers" wrote in message ... Got a friend selling these pretty cheap, thought I'd pass it along. BTW, Early on I had a PC die, power seemed OK, but the mother board was dead. Without a thought in the world about the power supply being the cause I replaced the board and it promptly died. My buddy, who sold me the board (new), told me a number of points where I must have screwed up and placing my faith in him I said I'd replace the board (again) but after saying the board may have been bad to start with. Taking this as an insult to his pride, he took the a new board off the self, tested it, installed it and it died. At that point he went looking for the cause and found that the power supply was pumping some odd over voltages on the 5 & 12 volt circuits. Apparently not enough to kill the fan or the HDs, just the mother board. He was some what embarrassed and as a way of joking about it bought both of us pocket sized voltage test meters (still have mine). So in light of a number of recent post about power issues, I offer this. KMC 20 Pin ATX Tester CoolMax 20 pin ATX power supply tester. Quickly isolate and verify power supply failures. Checks all ATX output voltages, +3.3V, -12V, PG, +12V, +5VSB, -5V, and +5V via LED light. Also checks 4 pin peripheral connectors, floppy drive connectors and ATX12V connectors for proper outputs. Very handy and easy to use. Suitable for any ATX power supply with 20 pin mainboard connector. Instructions stamped directly on tester. Retail packed. Availability: Usually ships the same business day 20-pin-atx-tester price: $9 There is like 1 to 100,000 chance you will ever benefit from such a device. plua having an LED light up will tell you that you have voltage....but not if the voltage is correct or within spec |
#4
|
|||
|
|||
20 Pin ATX Tester
Kevin Childers wrote:
Got a friend selling these pretty cheap, thought I'd pass it along. BTW, Early on I had a PC die, power seemed OK, but the mother board was dead. Without a thought in the world about the power supply being the cause I replaced the board and it promptly died. My buddy, who sold me the board (new), told me a number of points where I must have screwed up and placing my faith in him I said I'd replace the board (again) but after saying the board may have been bad to start with. Taking this as an insult to his pride, he took the a new board off the self, tested it, installed it and it died. At that point he went looking for the cause and found that the power supply was pumping some odd over voltages on the 5 & 12 volt circuits. Apparently not enough to kill the fan or the HDs, just the mother board. He was some what embarrassed and as a way of joking about it bought both of us pocket sized voltage test meters (still have mine). So in light of a number of recent post about power issues, I offer this. KMC *20 Pin ATX Tester* CoolMax 20 pin ATX power supply tester. Quickly isolate and verify power supply failures. Checks all ATX output voltages, +3.3V, -12V, PG, +12V, +5VSB, -5V, and +5V via LED light. Also checks 4 pin peripheral connectors, floppy drive connectors and ATX12V connectors for proper outputs. Very handy and easy to use. Suitable for any ATX power supply with 20 pin mainboard connector. Instructions stamped directly on tester. Retail packed. Availability: Usually ships the same business day 20-pin-atx-tester price: *$9* My power supply testers are old, but still functional, motherboards plus a POST card (I have spare POST cards, too) that signals whether or not the 3.3v, 5v, and 12v circuits are within tolerance. If a power supply blows up a motherboard (Hello, Bestec!), then the board goes to scrap, and another one takes its place. I had to be sure I kept enough motherboard-power-supply-testers around when I hauled off a bunch of obsolete boards to the local electronic scrap dealer who used his Midas touch to turn the boards into money for me. And then we have the newer 24-pin ATX form factor power supplies with a pair of 12v leads to the motherboard in a 4-pin connector... Ben Myers |
#5
|
|||
|
|||
20 Pin ATX Tester
On Jan 2, 8:07*pm, Ben Myers wrote:
Kevin Childers wrote: Got a friend selling these pretty cheap, thought I'd pass it along. * BTW, Early on I had a PC die, power seemed OK, but the mother board was dead. *Without a thought in the world about the power supply being the cause I replaced the board and it promptly died. *My buddy, who sold me the board (new), told me a number of points where I must have screwed up and placing my faith in him I said I'd replace the board (again) but after saying the board may have been bad to start with. *Taking this as an insult to his pride, he took the a new board off the self, tested it, installed it and it died. *At that point he went looking for the cause and found that the power supply was pumping some odd over voltages on the 5 & 12 volt circuits. *Apparently not enough to kill the fan or the HDs, just the mother board. *He was some what embarrassed and as a way of joking about it bought both of us pocket sized voltage test meters (still have mine). So in light of a number of recent post about power issues, I offer this.. KMC *20 Pin ATX Tester* CoolMax 20 pin ATX power supply tester. Quickly isolate and verify power supply failures. Checks all ATX output voltages, +3.3V, -12V, PG, +12V, +5VSB, -5V, and +5V via LED light. Also checks 4 pin peripheral connectors, floppy drive connectors and ATX12V connectors for proper outputs. Very handy and easy to use. Suitable for any ATX power supply with 20 pin mainboard connector. Instructions stamped directly on tester. Retail packed. Availability: Usually ships the same business day 20-pin-atx-tester * *price: *$9* My power supply testers are old, but still functional, motherboards plus a POST card (I have spare POST cards, too) that signals whether or not the 3.3v, 5v, and 12v circuits are within tolerance. *If a power supply blows up a motherboard (Hello, Bestec!), then the board goes to scrap, and another one takes its place. *I had to be sure I kept enough motherboard-power-supply-testers around when I hauled off a bunch of obsolete boards to the local electronic scrap dealer who used his Midas touch to turn the boards into money for me. And then we have the newer 24-pin ATX form factor power supplies with a pair of 12v leads to the motherboard in a 4-pin connector... Ben Myers All I can add...I had a PC shop owner test the one I suspected (ruptured electolytic) and it tested good with all idiot lights on! The bad PS would only light the green reserve power light on the m/b. (so much for fast diagnostics) |
#6
|
|||
|
|||
20 Pin ATX Tester
On Jan 3, 8:55*am, wrote:
All I can add...I had a PC shop owner test the one I suspected (ruptured electolytic) and it tested good with all idiot lights on! That misinformation is typical of power supply testers. Three conditions exist. Definitively good, definitively bad, and unknown. A power supply tester can only identify a power supply as definitively bad or unknown. For the same money, a tool that also has numerous other purposes (multimeter) can determine all three states. Meanwhile, any standard power supply must never damage a motherboard or peripherals. And a motherboard must never damage a power supply. Best way to test a power supply is with it connected to the computer. IOW don't disconnect anything and get numbers from the multimeter. It is not just a power supply. It is a power supply 'system'. Unlike a tester, numbers from a multimeter can even identify in minutes other problems such as failure of the power supply controller. Testers are popular where one fears numbers. For a useful answer (not using junk science reasoning), numbers are essential. A multimeter provides numbers so that significant and useful information can move the entire supply 'system' from unknown to either good or bad - without doubts. A tester cannot do that. Same multimeter works for 20 pin ATX connectors, 24 pin connectors, future power supplies, and so many other solutions such as household wiring, electrical appliances, and automobile problems. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
20 Pin ATX Tester | Kevin Childers | Acer Computers | 0 | January 2nd 09 03:07 PM |
20 Pin ATX Tester | Kevin Childers | Compaq Computers | 0 | January 2nd 09 03:07 PM |
20 Pin ATX Tester | Kevin Childers | Compaq Servers | 0 | January 2nd 09 03:06 PM |
DDR Tester? | Jethro | General | 10 | March 19th 07 07:36 AM |
lan tester help | James | General | 1 | August 16th 03 12:50 PM |