A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » General Hardware & Peripherals » Cdr
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Has anyone burnt an 80-min CD-R on a 7200i / CDD3610 under Linux?



 
 
Thread Tools Display Modes
  #1  
Old February 22nd 04, 10:00 PM
Paul
external usenet poster
 
Posts: n/a
Default Has anyone burnt an 80-min CD-R on a 7200i / CDD3610 under Linux?

After hearing the whispers that the HP CDWriter+ 7200i / Philips
CDD3610 can happily burn 80-min CDs, I've upgraded my 7200i's firmware
to r. 3.09, and have tried burning an 80-min audio CD. It seemed to
pass the OPC, and appeared to have no trouble with the first track,
but then cdrecord spat this out:

Track 01: Total bytes read/written: 31641456/31641456 (13453
sectors).
cdrecord: Input/output error. flush cache: scsi sendcmd: no error
CDB: 35 00 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 00 00 00 00 00 00 00 00
Sense Key: 0xFFFFFFFF [], Segment 0
Sense Code: 0x00 Qual 0x00 (no additional sense information) Fru
0x0
Sense flags: Blk 0 (not valid)
cmd finished after 124.045s timeout 120s
Trouble flushing the cache

Now the cdrecord man page says that

The following message is not an error:
Track 01: Total bytes read/written: 2048/2048 (1 sectors).
cdrecord: I/O error. flush cache: scsi sendcmd: no error
CDB: 35 00 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: F0 00 05 80 00 00 27 0A 00 00 00 00 B5 00 00 00
00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0xB5 Qual 0x00 (dummy data blocks added) Fru 0x0
Sense flags: Blk -2147483609 (valid)
cmd finished after 0.002s timeout 40s

It simply notifies, that a track that is smaller than the
minimum size has been expanded to 300 sectors.

This error looks just like the one I have, but the track size on mine
is 30MB! Not smaller than the minimum size, one would think!

The command I used was
`cdrecord -v speed=2 dev=0,0,0 -audio -pad *.wav`.

I've managed to record the same set of audio tracks on a 74-min
Imation CD-RW. So has anyone out there used an HP 7200i or a Philips
CDD3610 to burn 80-minute audio CDs successfully? I've read many
times that it can be done - but how?! Any help much appreciated!
Thanks,

Paul.

And now the details:

The CD-Writer's the slave on ide1 (/dev/hdd), and I'm running
Slackware 9.0.
The media: Sony CD-R CDQ80N4 (1x-40x compatible)

Here's the relevant stuff from `dmesg`:

hdd: HP CD-Writer+ 7200, ATAPI CD/DVD-ROM drive
ide1 at 0x170-0x177,0x376 on irq 15
SCSI subsystem driver Revision: 1.00
kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2
kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2
kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2
hdd: attached ide-scsi driver.
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
Vendor: HP Model: CD-Writer+ 7200 Rev: 3.09
Type: CD-ROM ANSI SCSI revision: 02
Attached scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0
sr0: scsi3-mmc drive: 6x/6x writer cd/rw xa/form2 cdda tray

Output of `cdrecord -v speed=2 dev=0,0,0 -audio -pad *.wav`

scsidev: '0,0,0'
scsibus: 0 target: 0 lun: 0
Linux sg driver version: 3.1.25
Cdrecord 2.00.3 (i686-pc-linux-gnu) Copyright (C) 1995-2002 Jörg
Schilling
TOC Type: 0 = CD-DA
Using libscg version 'schily-0.7'
atapi: 1
Device type : Removable CD-ROM
Version : 0
Response Format: 1
Vendor_info : 'HP '
Identifikation : 'CD-Writer+ 7200 '
Revision : '3.09'
Device seems to be: Generic mmc CD-RW.
Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
Driver flags : MMC SWABAUDIO
Supported modes: TAO PACKET RAW/R16
Drive buf size : 786432 = 768 KB
FIFO size : 4194304 = 4096 KB
Track 01: audio 30 MB (02:59.37) no preemp
Track 02: audio 25 MB (02:29.42) no preemp
Track 03: audio 31 MB (03:09.40) no preemp
Track 04: audio 40 MB (04:03.48) no preemp
Track 05: audio 31 MB (03:09.45) no preemp
Track 06: audio 38 MB (03:50.77) no preemp
Track 07: audio 37 MB (03:43.18) no preemp
Track 08: audio 54 MB (05:22.10) no preemp
Track 09: audio 40 MB (03:59.48) no preemp
Track 10: audio 38 MB (03:51.44) no preemp
Track 11: audio 29 MB (02:56.26) no preemp
Track 12: audio 48 MB (04:51.18) no preemp
Track 13: audio 27 MB (02:46.17) no preemp
Track 14: audio 40 MB (04:00.80) no preemp
Track 15: audio 40 MB (04:03.50) no preemp
Track 16: audio 40 MB (03:58.69) no preemp
Track 17: audio 29 MB (02:53.26) no preemp
Total size: 632 MB (62:40.01) = 282001 sectors
Lout start: 632 MB (62:42/01) = 282001 sectors
Current Secsize: 2048
ATIP start of lead in: -11835 (97:24/15)
ATIP start of lead out: 359849 (79:59/74)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 24
Manufacturer: SONY Corporation
Blocks total: 359849 Blocks current: 359849 Blocks remaining: 77848
Starting to write CD/DVD at speed 2 in real TAO mode for single
session.
Last chance to quit, starting real write in 0 seconds.
Operation starts.
Waiting for reader process to fill input buffer ... input buffer
ready.
Performing OPC...
Starting new track at sector: 0
Track 01: Total bytes read/written: 31641456/31641456 (13453 sectors).
cdrecord: Input/output error. flush cache: scsi sendcmd: no error
CDB: 35 00 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 00 00 00 00 00 00 00 00
Sense Key: 0xFFFFFFFF [], Segment 0
Sense Code: 0x00 Qual 0x00 (no additional sense information) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 124.045s timeout 120s
Trouble flushing the cache
Writing time: 220.598s
Average write speed 17.5x.
Min drive buffer fill was 98%
Fixating...
cdrecord: Input/output error. close track/session: scsi sendcmd: no
error
CDB: 5B 00 02 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 00 00 00 00 00 00 00 00
Sense Key: 0xFFFFFFFF [], Segment 0
Sense Code: 0x00 Qual 0x00 (no additional sense information) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 1.998s timeout 480s
cmd finished after 1.998s timeout 480s
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Since powersupply burnt out motherboard, what to do with components? S.Heenan General 4 August 11th 03 03:15 PM
CPU burnt or alive ? rim Homebuilt PC's 5 July 9th 03 11:00 PM
'Burnt out' pins on DDR memory- can it be salvaged? Li'l ol' me General 5 July 3rd 03 02:08 PM


All times are GMT +1. The time now is 01:22 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Copyright ©2004-2022 HardwareBanter.
The comments are property of their posters.