If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
how to get into setup after battery dead?
Which Presario? 900 series?
HH "Gary Roach" wrote in message ... I booted my compaq presario 486dx 2/66 and the bios told me that the date and time had been lost. however, it booted into windows 98. i shut it down, replaced the battery, and now it says at bootup: 1782-Disk Controller Failure 1792-Secondary Disk Controller Failure 162-Options not set i assume i need to go into setup and reset some lost settings. but i can't get into setup. i've got compaq setup disk on floppy but the computer doesn't go to the floppy. what do i do? thanks for the help gary -- Gary Roach ADB Services |
#2
|
|||
|
|||
Same problem, no setup disks etc. It a compaq presario 5108us
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Laptop Battery Problems | Shannon L | General | 2 | February 22nd 04 07:58 AM |
recharge/replace UPS batteries? | [email protected] | General | 2 | February 16th 04 11:46 PM |
EVO N150 battery problem | Jim Gieszelmann | Compaq Computers | 0 | December 4th 03 02:14 AM |
Armada M300 battery | Rob Wheatley | Compaq Computers | 1 | October 21st 03 09:35 PM |
Battery Drain!! | [email protected] | Compaq Computers | 0 | September 7th 03 03:30 PM |