If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Zebra TLP 2844
I have a problem printing labels with a Zebra TLP2844.
In VS2005 C# I wrote these few lines using "Waterfurnace.ZebraPrint" library zPrint.StartWrite(System.Configuration.Configurati onManager.AppSettings["PrinterPath"]); zPrint.Write("N"); zPrint.Write("A220,300,0,4,1,1,N,\"TEST\""); zPrint.Write("B220,120,0,E30,3,20,100,B,\"" + strBarcode + "\""); zPrint.Write("P1"); zPrint.EndWrite(); It works quite well, the problem is that before and after the label, it prints a blank label (the sequence is "blank label"-"correct label"-"blank label"). Where is the error? Thank you in advance Daniele |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Zebra ZPL help | [email protected] | Printers | 1 | March 21st 06 02:36 PM |
Zebra Z6M Plus Printer | Melanie Foster | Printers | 2 | August 27th 04 04:12 PM |
Zebra TLP 2844 | Eitan | Printers | 2 | February 5th 04 08:55 AM |
WTB: Zebra 2844 logic board | LB | Printers | 0 | October 3rd 03 06:02 AM |
Zebra 2844 UPS firmware needed | Lee B. | Printers | 0 | September 25th 03 12:32 AM |