If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
configuration of switch brocade
Hello everybody.
I want to write a script to connect on a switch and get information as switchshow and portshow. In tne past, I use expect to connect and get information in a file. Is there any other way ? Thanks in advance Gilles |
#2
|
|||
|
|||
configuration of switch brocade
On Mar 8, 3:46 pm, "Regine dessoubret" wrote:
Hello everybody. I want to write a script to connect on a switch and get information as switchshow and portshow. In tne past, I use expect to connect and get information in a file. Is there any other way ? You could try using SNMP GETs, Brocades do support the FC switch MIB. It really depends on what kind of information you are trying to get at, and how much work you are willing to put into maintaining the scripts when the switches upgrade. The MIB follows a standard, so it's more likely to keep working across firmware upgrades. Using expect to use the cli can break without any guarantees, but then you might be able to get some information that's not in the FC switch MIB standard.... Arne |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HP B-Series Fibre Switch / Brocade 3200 | Will | Compaq Servers | 2 | February 10th 07 12:40 AM |
Brocade help: can't see drives through only one switch | Ben | Storage & Hardrives | 7 | April 7th 05 07:55 AM |
brocade SAN switch question | zombie | Storage & Hardrives | 4 | August 16th 04 07:17 PM |
Brocade Switch | Bill Johnson | General Hardware | 0 | May 20th 04 05:54 PM |
Brocade switch 2800 problem | Shri | Storage & Hardrives | 0 | January 15th 04 01:26 PM |