If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Hard Drive Question
Are most harddrives backwards compatible? I am looking at MAXTOR 60GB
7200RPM EIDE HARD DRIVE MODEL # 6Y060L0 - OEM, DRIVE ONLY DiamondMax Plus 9 Specifications: Size: 60 Gigabytes Interface: IDE ULTRA ATA133 Seek time: 9 msec RPM:7200 Cache 2MB and it only says ATA133. So I don't have to have a special cable? Thanks maybe I can return the favor in information one day. |
#2
|
|||
|
|||
If you are talking about the old 40 pin flat ribbon cable, then yes. It
should work. However, make sure your drive is set to "master" (for single Hard drive) or "slave" (for second hard drive on same cable). Do not use "cable select" because that jumper only works with the 80 pin flat cable. Hope this helps, D. "jm" wrote in message news:JzGVa.15058$Ho3.2592@sccrnsc03... Are most harddrives backwards compatible? I am looking at MAXTOR 60GB 7200RPM EIDE HARD DRIVE MODEL # 6Y060L0 - OEM, DRIVE ONLY DiamondMax Plus 9 Specifications: Size: 60 Gigabytes Interface: IDE ULTRA ATA133 Seek time: 9 msec RPM:7200 Cache 2MB and it only says ATA133. So I don't have to have a special cable? Thanks maybe I can return the favor in information one day. |
#3
|
|||
|
|||
Howdy!
"D" wrote in message ... If you are talking about the old 40 pin flat ribbon cable, then yes. It should work. However, make sure your drive is set to "master" (for single Hard drive) or "slave" (for second hard drive on same cable). Do not use "cable select" because that jumper only works with the 80 pin flat cable. It DOES? *looks at Compaq 40 wire cable select cable stuck to the desk as a trophy* That's rather news to some of us ... Although your TYPICAL 40 wire cable isn't cable select, true. But it doesn't "only work with the 80 pin flat cable", either. RwP |
#4
|
|||
|
|||
D wrote:
If you are talking about the old 40 pin flat ribbon cable, then yes. It should work. However, make sure your drive is set to "master" (for single Hard drive) or "slave" (for second hard drive on same cable). Do not use "cable select" because that jumper only works with the 80 pin flat cable. I believe it's actually 80 wire cable, not 80 pin. http://www.pcguide.com/ref/hdd/if/ide/confCS-c.html Tom |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hard Drive, external - cheapest way to go? | Big Mac | General | 8 | May 6th 04 04:56 AM |
Is my hard drive the source of my CD burning woes? | Jonathan King | General | 4 | March 19th 04 12:06 AM |
two hd's on same IDE channel | Steve James | General | 25 | March 13th 04 12:06 AM |
Multi-boot Windows XP without special software | Timothy Daniels | General | 11 | December 12th 03 05:38 AM |