If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Path fail-over for SUSe 9
I am looking for a path fail-over product for SUSe Linux 9. I have four
DL380(G4)'s each with two QLogic QLA 2340-E-SP attached to two McData 4500 switches. These are connected to an EMC Clariion CX500 array. EMC's PowerPath is not certified on SUSe 9. Any suggestions? Thanks, Rick |
#2
|
|||
|
|||
Qlogic has multipath capabilities for most of their drivers. I would
look at the SUSE 9 drivers and see if the MP capabilites of this driver set are sufficient. |
#3
|
|||
|
|||
On a Sun box I would use Veritas DMP which comes with Volume Manager. I
believe Volume Manager is available for Linux and may offer a DMP solution for you. On a Solaris system with vxvm you would just need to get the clarion ASL, array support library an VxVM version 3.2. Regards, Vic |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
lightning strike - should the components be reused | rello | General | 19 | May 5th 04 01:03 AM |
lightning strike - should the components be reused | rello | Homebuilt PC's | 18 | May 5th 04 01:03 AM |
Asus P4P800 Deluxe CPU fail | xyz | Asus Motherboards | 4 | April 10th 04 12:46 AM |
Upgrade Path | Cougar | General Hardware | 1 | February 4th 04 11:21 PM |
Logitech ImageStudio - Changing save path | Stein Arne Storslett | Webcams | 0 | February 4th 04 11:51 AM |