|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 29th 03, 12:58 PM
|
|||
|
|||
Backup Exec 9 and Media Sets
I run Veritas Backup Exec 9.0 attached to a Compaq MSL5026 Media
Library with 2 SDLT 110/220 tape drives. I have a media set created called Monthly which is used for full weekly backups of my servers. My problem is that say I have two tapes, both which have 50gb of space free. The backup starts and uses the first tape, and then when this is full, should then take the other tape to finish the backup. Instead what is happening is that the backup asks for a scratch media. I have verified that 1. The "Media Overwrite Protection level" is set to "Partial" in the ToolsOptionsMedia management 2. The "Overwrite protection period" in the Media properties is not set to "Infinite-don't allow overwrite" Any ideas please? Konrad 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pc problems after g card upgrade + sp2 | ben reed | Homebuilt PC's | 9 | November 30th 04 01:04 AM |
| RAID card for my PC?? | TANKIE | General | 5 | May 22nd 04 01:09 AM |
| Networker/NDMP backup problems | Michael Taylor | Storage & Hardrives | 0 | November 5th 03 04:14 PM |
| Help: Backup Exec 9.0 backup on to Plextor DVD+RW via Roxio | Jeff Ishaq | Cdr | 0 | October 22nd 03 06:39 PM |
| Help: Backup Exec 9.0 backup on to Plextor DVD+RW via Roxio | Jeff Ishaq | Storage & Hardrives | 0 | October 22nd 03 06:39 PM |
Linear Mode
