If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
'clocking xp-ms
firstly, i've been building pcs for about 12 years, now - for reliability &
stock perfotmance rather than oc i have an abit nf7-sg2 with xp3000bar333 which no longer cuts the mustard; but as luck would have it, i also have a couple xp-m2400s & silverado hsfs near mirror finish/zalman copper flowers + big fans/cooljag\jaq??? {these have tiny, fast fans so have never been plugged in--freeebies with xp-tmcs} & shin etsu/arctic silver. ram =corsair value 3200 2x256kit, ie=200mhz -i find no difference in performance [ie 3d01/03/05 results are identical] running this at 333 or 400 but it is more stable at 400 - i get hard locks if i run it at 333 [yes i have narrowed it down to ram speed settings], also setting exact speeds/delays in bios doesn't help. as you've probably guessed, i want to stick a mobile in. i've already got the xp-ms shoved into xp-tmcs which are 'wire modded', as per ocinside instructions, for 1.65v & 1.75 {x12multi}; my main question, will i also need to mod the cpus/tmcs for fsb? - default is 133[266ddr]{x6} with xp-ms, (133[266]. tmc=total multiplier control, so multi is taken care of but i want 200[400ddr]x12 or can i just select 200[400ddr] in bios & depend upon the tmcs to supply multi? 2nd ?. i'm not certain 1.65v{or 1.75} will be enough for this speed. i also may want to push the multiplier beyond 12, this is the main reason i've wire modded the tmcs for voltage, its reversible. can any xp-m oc vets tell me if i'm in the right ball park, voltage-wise? how far can i expect to push an xp-m2400 with air cooling? for reference. cpu, ram & psu are at 32c +- 1c at idle; 36+-2c under 6hours heavy load {cs.s}. dr ratt |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
performance question regarding over clocking | eric | Overclocking | 0 | July 1st 04 09:31 AM |
How is clocking in latest processor(P4,AMD,etc) | jinesh | General Hardware | 0 | May 31st 04 05:01 PM |
CPU Over clocking | redrider | Overclocking | 17 | March 15th 04 11:01 AM |
RAM clocking | Kirk | Overclocking | 3 | December 9th 03 05:01 PM |
Under Clocking & Over Volting to Burn In A New Processor | Mark Weatherill | Overclocking AMD Processors | 8 | September 1st 03 05:09 PM |