If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Agfa Duoscan T1200 error msg
I bought an Agfa Duoscan T1200 scanner along with a SCSI-USB converter
to scan some antique glass plate negatives. It works find in reflective mode, but in negative or transparancy mode, I get the error message: "A calibration error has occurred. Make sure the calibration hole of the transparency tray is not covered and that the transparency tray is fully inserted." This error message comes up both when the tray is fully inserted and when it is fully removed. I assume the slot in the front of the transparancy tray is the calibration hole. It is not blocked. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Agfa Scanwise 2.0.0.9 | khw46 | Scanners | 1 | January 9th 06 09:04 PM |
Agfa Snapscan 1212p | vvega | Scanners | 4 | August 10th 04 03:43 PM |
agfa duoscan | sandro | Scanners | 0 | January 27th 04 06:53 PM |
Software for AGFA | vvega | Scanners | 2 | September 3rd 03 02:51 PM |
Agfa StudioScan IIsi | JaKKe | Scanners | 0 | July 1st 03 08:44 PM |