If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
newbie: attach CDRW as slave?
I am about to build up an Athlon XP2500 computer. I will have one hard
disk, one CDRW-DVD combo drive and one floppy disk drive. How do most of you connect the CDRW, i.e. to the same EIDE controller as the hard drive (as slave and HD as master), or do you use the second EIDE controller seperately? Larry Gagnon *************** remove "fake" from email address |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CDRW not being detected as pri or sec slave... | Fredericks | General | 2 | April 18th 04 10:01 PM |
lost primary slave when installing ASUS A7V8X-X | BC Berry | General | 3 | January 1st 04 03:33 AM |
Slave or Master | RanMan | General | 6 | December 21st 03 12:32 AM |
DVD / CDRW drive master slave situation | - | General | 3 | November 24th 03 11:23 PM |
set CDROM as master not slave? | kony | General | 1 | June 28th 03 07:40 AM |