If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
P2bf - Auto detect WD 26400 ?
- Bob - wrote:
My P2Bf will not auto detect a WD 26400 (6gb) during boot. It's set to "auto", the system waits a while and looks during boot, but it shows up as "none" and then moves on. However, If I go into the BIOS and run the IDE Drive Detection it does just fine and pulls all the info, setting it to "User" instead of "Auto". Runs fine after that. Shouldn't it be able to find the drive through either mechanism? (I admit to the BIOS being old and dated on this mobo). Thanks, Bob The P2BF should auto detect, and support, that WD drive, without problem. Do you have the drive jumpered properly? If it is the ONLY hard drive on the primary or secondary controller, jumper the WD drive as Single, if there are two drives on the controller then use the Dual Master/Slave jumpers. Good luck, Steven |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HD not listed in or auto detected by bios | Guy Smith | General | 2 | September 10th 04 12:59 PM |
A8V random reboots - Turn off BIOS "auto" settings? | Bill | Asus Motherboards | 11 | August 21st 04 11:04 PM |
My Athlon 1.2 Asus A7 mobo system can't detect SDRAM memory. | »¨ºÃÂú ÔÂBeautiful Flowers Full Moon | Asus Motherboards | 9 | May 11th 04 08:43 AM |
Athlon 1.2 Asus A7 mobo system can't detect SDRAM memory. | »¨ºÃÂú ÔÂBeautiful Flowers Full Moon | Overclocking AMD Processors | 6 | May 6th 04 12:12 AM |
Nero 6 CD-ROM auto detect? | Richard Dower | Cdr | 0 | July 31st 03 02:12 AM |