If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Brother HQ1200, HRC and Toner Save features...
Hi Everyone!
I just bought a refurbished Brother HL-1650 printer. So far so good, it prints great, hopefully it'll last as well. Going over some of the features of the printer I noticed under print quality the term HRC (High Resolution Control). I did a couple of test prints with the HRC feature on/off and really could not tell much of a difference in the print. Can anyone tell me a bit more about this? Are there only certain types of print jobs that make use of this feature? How about the HQ1200 feature? It is part of the resolution setting, and I'm assuming it basically somehow achieves the 1200 dpi print density. The print difference however is obvious between HQ1200 and 600 dpi. I would imagine that HQ1200 uses more toner since the print does look darker. Finally there is the Toner Save feature...tried it but wasn't too happy with the "washed out" printout...I think I'll skip this and simply print using the normal settings. I'm just curious if folks out there are seeing a noticeable difference in the toner life with this turned on? Thanks again, if there are any hints/tips that I should know about using this printer by all means please let me know. - Dariusz =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-= Dariusz Piatkowski dariusz ! at ! mnsi.net, http://www.mnsi.net/~dariusz New Concepts Consulting - Your One Stop For Hardware & Software Solutions Windsor, Ontario, Canada, call (519) 380-0384 =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-= |
Thread Tools | |
Display Modes | |
|
|