If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
"lightscribe disc information encoded in the middle of the disc could not be read"
This is just a heads-up to those lucky enough to know how to search the
newsgroups for issues like this. I recently purchased a new Compaq with an HP dvd740b LightScribe drive. I also purchased a 5-pak of HP CD-R 52x "for LightScribe Direct Disc Labeling enabled Burners". Finally, I purchased Nero 7 and installed that on this system. Hours have been lost due to the message "lightscribe disc information encoded in the middle of the disc could not be read". Software has been uninstalled and, some, re-installed - due to reports that the software that came with the system (Sonic) does not necessarily cohabitate well with Nero. In the end, the issue was NEVER the software, but the CD-R's themselves. I first was able to burn a label on a Verbatim DVD+R for LightScribe w/o issue. I then went and purchased a 10-pak of Memorex CD-R for LightScribe and they work just fine, too. So, HP CD-R 52x LightScribe media may be your issue, too, if you get this error. Try to burn the label FIRST before putting data on a single disk in the pack so you have some ability to return them if they're defective. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
my new mobo o/c's great | rockerrock | Overclocking AMD Processors | 9 | June 30th 04 08:17 PM |
When Good Discs Go Bad | Ablang | General | 0 | June 27th 04 03:47 AM |
can someone look at this? | steve | General | 3 | March 1st 04 11:11 PM |
help?? | steve | General | 11 | February 11th 04 05:08 PM |
PC generating unusual "chirrupy" sound? | Coda | General Hardware | 1 | November 20th 03 07:52 PM |