If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
FATALITY 939 Warning
This board will not do cas 2.5 or cas 3 with g skill LE 2 x 512 out of box or for overclocking with this memmory. I am presently stuck at cas 2 for overclocking an if i move it to cas 2.5 or cas 3 it bitches an errors like hell. And more voltage does nothing to help an tryed arranging other memmory settings also to no avail. Also you cant turn off several hidden bios functions like thermal trottlng for instance etc etc. An i get no replys to my e mails to them about it. Other memmory may be ok but remeber its mem voltage only goes to 2.8 not good enough in my book. Especially since its being cooled by otes stuff youd think it was ready to be overclocked but its crippled an probably intentionally as to not ruin future sales of faster boards. And lastly this is by far my first build so it is not my exsperience level with over 30 systems ive built this is first that would not do cas 2.5 or cas 3. And i bought the memmory knowing of the limitation of memmory voltage g skill is good at overclocking with less voltage. But i could never have dreamed or imagined of it not liking cas 2.5 or 3, YOURE WARNED
|
#2
|
|||
|
|||
Update memory was bad on that board. Replaced them an it is now fine.
"LostSoul" wrote in message ... This board will not do cas 2.5 or cas 3 with g skill LE 2 x 512 out of box or for overclocking with this memmory. I am presently stuck at cas 2 for overclocking an if i move it to cas 2.5 or cas 3 it bitches an errors like hell. And more voltage does nothing to help an tryed arranging other memmory settings also to no avail. Also you cant turn off several hidden bios functions like thermal trottlng for instance etc etc. An i get no replys to my e mails to them about it. Other memmory may be ok but remeber its mem voltage only goes to 2.8 not good enough in my book. Especially since its being cooled by otes stuff youd think it was ready to be overclocked but its crippled an probably intentionally as to not ruin future sales of faster boards. And lastly this is by far my first build so it is not my exsperience level with over 30 systems ive built this is first that would not do cas 2.5 or cas 3. And i bought the memmory knowing of the limitation of memmory voltage g skill is good at overclocking with less voltage. But i could never have dreamed or imagined of it not liking cas 2.5 or 3, YOURE WARNED |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Warning on boot up ? comes on again | kenward. rfe | Gigabyte Motherboards | 3 | August 18th 04 12:44 PM |
can someone look at this? | steve | General | 3 | March 1st 04 11:11 PM |
Installing Ati Radeon 9700 drivers to Mandrake Linux 9.2 | Meinz | General Hardware | 2 | January 15th 04 06:09 PM |
Cpu Warning | Samantha Armstrong | Overclocking AMD Processors | 3 | November 28th 03 10:09 AM |
"System temperature too high" warning | Dave Ulrick | Homebuilt PC's | 0 | September 3rd 03 03:03 PM |