|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 28th 04, 12:30 AM
|
|||
|
|||
Chaintech GF2 mx400 hoses Ga-7VT600 ?
Gents:
Has anyone observed, that the CT GF2 mx400 vidcard [ AGP 2x/4x ] hoses the Ga-7VT600 [ AGP 4x/8x ] mobo ? I'm about to re-try a systems build , and the above conflict would explain my initial failure. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Chaintech VNF4 ultras in stock at ZipZoomFly | [email protected] | General | 1 | January 19th 05 02:15 AM |
| amd64 3200 + Chaintech znf3-250 | Alexander | AMD x86-64 Processors | 0 | September 5th 04 03:30 PM |
| Any Thoughts on Chaintech Mb's | Canaan Apollyon | Homebuilt PC's | 3 | January 7th 04 01:16 AM |
| Chaintech 7NIF2 motherboard - memory problems | Wuahn | General | 1 | July 26th 03 01:29 PM |
| Chaintech support answer verification. | Hormel Bait | Homebuilt PC's | 4 | July 14th 03 06:05 AM |
Linear Mode
