|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 14th 08, 04:22 PM
posted to alt.comp.periphs.mainboard.gigabyte
|
|||
|
|||
Any way to stop power going to USB ports when PC turned off?
Motherboard is MA78GM-S2H. I have turned off the BIOS option to support USB
drives when booting. When the PC is turned off or put in standby the USB ports keep getting power. I have an external HDD and because the power stays on, it does not go into standby, which in turn means I cannot turn it off using its remote control. In other words, I have to get out of bed to turn it off! On my previous motherboard, when you turned off the PC, power to the USB ports was cut. Any way I can get this board behaving the same way? 
|
|
#2
June 15th 08, 02:44 AM
posted to alt.comp.periphs.mainboard.gigabyte
|
|||
|
|||
|
Any way to stop power going to USB ports when PC turned off?
On Sat, 14 Jun 2008 16:22:27 +0100, "GTS"
wrote: Motherboard is MA78GM-S2H. I have turned off the BIOS option to support USB drives when booting. When the PC is turned off or put in standby the USB ports keep getting power. I have an external HDD and because the power stays on, it does not go into standby, which in turn means I cannot turn it off using its remote control. In other words, I have to get out of bed to turn it off! On my previous motherboard, when you turned off the PC, power to the USB ports was cut. Any way I can get this board behaving the same way? Under Power Management Setup, try disabling USB Wakeup from S3.
|
|
#3
June 15th 08, 11:56 AM
posted to alt.comp.periphs.mainboard.gigabyte
|
|||
|
|||
|
Any way to stop power going to USB ports when PC turned off?
Under Power Management Setup, try disabling USB Wakeup from S3. Yep, tried that already, thank you. My last mobo did not support S3 stanby, only S1. Maybe if I set the Gigabyte to S1 in the bios all power will be cut...but I do like S3 standby! Will give it a try though...
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Power on/off on my computer works badly with power switch - sometimes computer runs on by itself, sometimes can't be turned on | MIUSS | Homebuilt PC's | 2 | September 21st 07 05:51 AM |
| A7N8X-E Deluxe - USB ports not holding power intensity | PifGadget | Asus Motherboards | 4 | October 10th 04 11:49 PM |
| Power On, Green, Fans Start, Fans Stop, Flash Red | ...Mike | Compaq Computers | 1 | July 11th 04 12:38 PM |
| USB port adapter -> Multi USB ports existing ? Extending number of USB ports possible ? | Dances With Crows | General | 0 | December 14th 03 10:33 PM |
| Leave power turned on for Lazer printer?? | Jagzilla | Printers | 1 | December 1st 03 12:37 AM |
Linear Mode
