If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
3.10 + Omegadrivers
Hello all.
I currently have 3.8 drivers with the latest Omegadrivers installed over top. Im thinking of going to the 3.10. Do I have to uninstall any previous stuff first? The 3.9 driver was not too friendly with my 9500 pro card at times. This is on an XP Pro system. Thanks all, SL |
#2
|
|||
|
|||
I also have a 9500 pro and the new drivers work GREAT so far with all my
games. COD, MOHAA, Madden 2004 all tested ok. I had the 3.8 Omegadrivers and I just installed over the others. You have to uninstall the reg. ATI control panel if you have it but I had the Omega CP. Read the readme file on his site to see what else if anything you need to know. Good luck and enjoy Randy "SL" wrote in message t... Hello all. I currently have 3.8 drivers with the latest Omegadrivers installed over top. Im thinking of going to the 3.10. Do I have to uninstall any previous stuff first? The 3.9 driver was not too friendly with my 9500 pro card at times. This is on an XP Pro system. Thanks all, SL |
#3
|
|||
|
|||
"SL" wrote in message et...
Hello all. I currently have 3.8 drivers with the latest Omegadrivers installed over top. Im thinking of going to the 3.10. Do I have to uninstall any previous stuff first? The 3.9 driver was not too friendly with my 9500 pro card at times. This is on an XP Pro system. Thanks all, SL My 9500 Pro runs fine on 3.10 Cats from Omega Corner. BF1942 1.5 with the latest Desert Combat mod, resolution 1280x960 .. FULL DETAIL :-) And it runs nice! |
#4
|
|||
|
|||
I took the plunge shortly after posting. I found a link posted quite
recently in here . Thanks to who ever that was. I have the latest omega drivers with 3.10 and so far they seem fine. I have yet to do any hard gaming yet. That will be my test. Oh, I havent had the Ati control panel for some time. So the need to remove it was not necessary. I also read the "readme" file. It claimed the removal of old drivers is not necessary. Once reading that, It basically answered my original question. I should of have remembered doing that process back in 3.8, 3.9 etc... thanks, SL "Dark Avenger" wrote in message om... "SL" wrote in message et... Hello all. I currently have 3.8 drivers with the latest Omegadrivers installed over top. Im thinking of going to the 3.10. Do I have to uninstall any previous stuff first? The 3.9 driver was not too friendly with my 9500 pro card at times. This is on an XP Pro system. Thanks all, SL My 9500 Pro runs fine on 3.10 Cats from Omega Corner. BF1942 1.5 with the latest Desert Combat mod, resolution 1280x960 .. FULL DETAIL :-) And it runs nice! |
#5
|
|||
|
|||
What happens if you don't remove
the old control panel bill "SL" wrote in message t... I took the plunge shortly after posting. I found a link posted quite recently in here . Thanks to who ever that was. I have the latest omega drivers with 3.10 and so far they seem fine. I have yet to do any hard gaming yet. That will be my test. Oh, I havent had the Ati control panel for some time. So the need to remove it was not necessary. I also read the "readme" file. It claimed the removal of old drivers is not necessary. Once reading that, It basically answered my original question. I should of have remembered doing that process back in 3.8, 3.9 etc... thanks, SL "Dark Avenger" wrote in message om... "SL" wrote in message et... Hello all. I currently have 3.8 drivers with the latest Omegadrivers installed over top. Im thinking of going to the 3.10. Do I have to uninstall any previous stuff first? The 3.9 driver was not too friendly with my 9500 pro card at times. This is on an XP Pro system. Thanks all, SL My 9500 Pro runs fine on 3.10 Cats from Omega Corner. BF1942 1.5 with the latest Desert Combat mod, resolution 1280x960 .. FULL DETAIL :-) And it runs nice! |
#6
|
|||
|
|||
it will mess-up and not load correctly if I remember correctly. His control
panel has tweaked settings for gaming. Randy Randy "bill" wrote in message .net... What happens if you don't remove the old control panel bill "SL" wrote in message t... I took the plunge shortly after posting. I found a link posted quite recently in here . Thanks to who ever that was. I have the latest omega drivers with 3.10 and so far they seem fine. I have yet to do any hard gaming yet. That will be my test. Oh, I havent had the Ati control panel for some time. So the need to remove it was not necessary. I also read the "readme" file. It claimed the removal of old drivers is not necessary. Once reading that, It basically answered my original question. I should of have remembered doing that process back in 3.8, 3.9 etc... thanks, SL "Dark Avenger" wrote in message om... "SL" wrote in message et... Hello all. I currently have 3.8 drivers with the latest Omegadrivers installed over top. Im thinking of going to the 3.10. Do I have to uninstall any previous stuff first? The 3.9 driver was not too friendly with my 9500 pro card at times. This is on an XP Pro system. Thanks all, SL My 9500 Pro runs fine on 3.10 Cats from Omega Corner. BF1942 1.5 with the latest Desert Combat mod, resolution 1280x960 .. FULL DETAIL :-) And it runs nice! |
#7
|
|||
|
|||
thanks guess i'll have to uninstall it and reinstall the drivers
bill "Randy" wrote in message ... it will mess-up and not load correctly if I remember correctly. His control panel has tweaked settings for gaming. Randy Randy "bill" wrote in message .net... What happens if you don't remove the old control panel bill "SL" wrote in message t... I took the plunge shortly after posting. I found a link posted quite recently in here . Thanks to who ever that was. I have the latest omega drivers with 3.10 and so far they seem fine. I have yet to do any hard gaming yet. That will be my test. Oh, I havent had the Ati control panel for some time. So the need to remove it was not necessary. I also read the "readme" file. It claimed the removal of old drivers is not necessary. Once reading that, It basically answered my original question. I should of have remembered doing that process back in 3.8, 3.9 etc... thanks, SL "Dark Avenger" wrote in message om... "SL" wrote in message et... Hello all. I currently have 3.8 drivers with the latest Omegadrivers installed over top. Im thinking of going to the 3.10. Do I have to uninstall any previous stuff first? The 3.9 driver was not too friendly with my 9500 pro card at times. This is on an XP Pro system. Thanks all, SL My 9500 Pro runs fine on 3.10 Cats from Omega Corner. BF1942 1.5 with the latest Desert Combat mod, resolution 1280x960 .. FULL DETAIL :-) And it runs nice! |
#8
|
|||
|
|||
Wow...what a difference with my latest addict game. Im into Command&Conquer
: Zero Hour. It was chugging a little slow for a capable pc. I switched to the latest Omegadrivers and it runs nice and smooth. I found it very smooth in all respects for 2D and especially 3D games so far. SL "bill" wrote in message .net... thanks guess i'll have to uninstall it and reinstall the drivers bill "Randy" wrote in message ... it will mess-up and not load correctly if I remember correctly. His control panel has tweaked settings for gaming. Randy Randy "bill" wrote in message .net... What happens if you don't remove the old control panel bill "SL" wrote in message t... I took the plunge shortly after posting. I found a link posted quite recently in here . Thanks to who ever that was. I have the latest omega drivers with 3.10 and so far they seem fine. I have yet to do any hard gaming yet. That will be my test. Oh, I havent had the Ati control panel for some time. So the need to remove it was not necessary. I also read the "readme" file. It claimed the removal of old drivers is not necessary. Once reading that, It basically answered my original question. I should of have remembered doing that process back in 3.8, 3.9 etc... thanks, SL "Dark Avenger" wrote in message om... "SL" wrote in message et... Hello all. I currently have 3.8 drivers with the latest Omegadrivers installed over top. Im thinking of going to the 3.10. Do I have to uninstall any previous stuff first? The 3.9 driver was not too friendly with my 9500 pro card at times. This is on an XP Pro system. Thanks all, SL My 9500 Pro runs fine on 3.10 Cats from Omega Corner. BF1942 1.5 with the latest Desert Combat mod, resolution 1280x960 .. FULL DETAIL :-) And it runs nice! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3.10 slower than 3.9 | KCB | Ati Videocards | 22 | December 24th 03 12:27 AM |
New Omega-Drivers (Cat 3.10) are out... | Thomas Engler | Ati Videocards | 0 | December 22nd 03 08:34 PM |
Halo and 3.10 Problems | Phoenix AG | Ati Videocards | 2 | December 22nd 03 04:24 PM |
Cat 3.10 still crashing with COD. | ChipHead | Ati Videocards | 9 | December 22nd 03 02:20 AM |
3.10 WDM for TV WONDER VE broken | sea53002003 | Ati Videocards | 0 | December 19th 03 03:40 AM |