|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 24th 04, 06:22 AM
|
|||
|
|||
MiTac 6513WU - Presario 7594
Does anyone know the max processor speed this board will accept?
Best I can do is: http://www.mitac.com/micweb/products...3wu/6513wu.htm which doesn't quite go that far. Thanks. __________________________________________________ _______________ JG... Jeff Givens "My hovercraft is full of eels." 
|
|
#2
August 24th 04, 10:46 AM
|
|||
|
|||
|
The onboard Intel 810E chipset should handle just about any Celeron or PIII
processor, short of a Tualatin. If you go with a 133MHz bus PIII, be sure to swap out the preinstalled DIMMs with PC133 DIMMs. HH "Jeff Givens" wrote in message ... Does anyone know the max processor speed this board will accept? Best I can do is: http://www.mitac.com/micweb/products...3wu/6513wu.htm which doesn't quite go that far. Thanks. __________________________________________________ _______________ JG... Jeff Givens "My hovercraft is full of eels."
|
|
#3
August 24th 04, 03:53 PM
|
|||
|
|||
|
On Tue, 24 Aug 2004 05:46:12 -0400 "HH" wrote:
The onboard Intel 810E chipset should handle just about any Celeron or PIII processor, short of a Tualatin. If you go with a 133MHz bus PIII, be sure to swap out the preinstalled DIMMs with PC133 DIMMs. Just picked up a 1 GHz 0.18 Celeron, should work nicely. Thx for info. __________________________________________________ _______________ JG... Jeff Givens "My hovercraft is full of eels."
|
|
#4
August 24th 04, 07:08 PM
|
|||
|
|||
|
If it has a 256K L2 cache it's a Tualatin Celeron and will not work. If it
has a 128K L2 cache, it's a Coppermine 1.1GHz Celeron and should work fine. HH "Jeff Givens" wrote in message ... On Tue, 24 Aug 2004 05:46:12 -0400 "HH" wrote: The onboard Intel 810E chipset should handle just about any Celeron or PIII processor, short of a Tualatin. If you go with a 133MHz bus PIII, be sure to swap out the preinstalled DIMMs with PC133 DIMMs. Just picked up a 1 GHz 0.18 Celeron, should work nicely. Thx for info. __________________________________________________ _______________ JG... Jeff Givens "My hovercraft is full of eels."
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| No sound or modem on Presario 7594 | No Spam | Compaq Computers | 1 | February 5th 04 02:09 AM |
| Upgrading Presario 7594 | BLS | Compaq Computers | 1 | February 4th 04 10:34 PM |
| Presario 524 Maxfax software | Mike Calkins | Compaq Computers | 1 | August 12th 03 12:59 AM |
| Problems with Presario 700 (711AU) | SFR | Compaq Computers | 1 | July 8th 03 10:34 AM |
| Presario 1250 monitor in Presario 1200? | Jaban | Compaq Computers | 0 | July 5th 03 12:10 AM |
Linear Mode
