If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
tape library partitioning
Hi All,
Supposing i partition a tape library into two logical libraries, can i assign both the logical libraries to the same server? If its possible, how does an application differentiate between the two logical library instances. i.e Would the device identification or serial number sent for a SCSI INQUIRY command be different for the two instances or would it be the same for all logical libraries ? regards, Penta |
#2
|
|||
|
|||
tape library partitioning
On May 26, 11:26 pm, penta wrote:
Hi All, Supposing i partition a tape library into two logical libraries, can i assign both the logical libraries to the same server? If its possible, how does an application differentiate between the two logical library instances. i.e Would the device identification or serial number sent for a SCSI INQUIRY command be different for the two instances or would it be the same for all logical libraries ? I mean the device identification or serial number for the medium changer devices. Thanks, penta |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3582 Tape Library | Mick | Storage (alternative) | 1 | February 13th 06 08:17 PM |
emulation of a tape library | mobidyc | Storage & Hardrives | 2 | December 20th 05 01:10 PM |
Partitioning library for Windows & Linux | Robert Bamler | Storage & Hardrives | 0 | November 19th 05 05:28 PM |
Low-End Netapp Compatilbe LTO Tape Library. | Osopolare | Storage & Hardrives | 1 | May 27th 05 02:52 AM |
Tape library question | Doug F | Compaq Servers | 1 | July 20th 04 02:24 AM |