If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cannot get standby mode to work on D845EBG2 board
Hello!
I am trying to get ACPI S3 Suspend to Ram to work on a 2.0GHz P4 and D845EBG2 motherboard. I have five other machines on which it works perfectly: two PIII Intel D815EEA boards, two PIII Intel D815EEA2 boards, and one old Gigabyte board with a Celeron 333 on it. All computers are hooked to a Netgear FVS318 firewall/router with a built-in 8-port 10/100 switch. The D815EEA and D815EEA2 boards all work fine, but the D845EBG2 board will not stay in standby. It will go into standby, but comes out almost immediately. If I disconnect the network cable, or turn off the router, or disable the Local Area Connection in the OS, it will go into standby and stay there until I hit a key or move the mouse. All the Intel boards have the same NIC listed and set to wake the system from standby (an Intel Pro/100 VE Network Connection NIC). I have changed ports on the router, made sure nothing is forwarded from the router to this machine's IP address, changed the IP address, and probably a few other things I cannot even remember. I need to have this thing in standby and wake up from the NIC when I access it remotely. Any ideas? OS is XP Professional 512MB DDR RAM Pentium 4 2.0GHz Intel onboard Pro/100 VE NIC ATI Rage 128 AGP 4x video WD 40GB hard drive 52X CDROM 3.5" Floppy Thank you for helping! Gregg |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
gateway mother board does not work | kyjim | Gateway Computers | 1 | April 8th 04 11:32 AM |
Can't get sound to work on Intel board | Jon Greene | General | 2 | October 23rd 03 07:11 PM |
will ddr agp card work on non ddr board ? | lee barlow | General | 1 | October 12th 03 05:17 PM |
Power Surge | David LeBrun | General | 44 | September 12th 03 02:35 AM |
UA133 work on a UA100 board? | J.Clarke | Storage (alternative) | 0 | August 11th 03 02:31 PM |