If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
3 pins on hdd
I have a Quantum 3.8gb hdd which has 3 pins.
* * * The hdd came with the Sony Vaio pcv-120. I cant find any info as to where to place the jumper to make the hdd slave. Does any one know what the jumper settings for it should be? -------------------------------------------------- *** E-mail is shut off *** -------------------------------------------------- |
#2
|
|||
|
|||
Previously Developwebsites wrote:
I have a Quantum 3.8gb hdd which has 3 pins. * * * The hdd came with the Sony Vaio pcv-120. I cant find any info as to where to place the jumper to make the hdd slave. Does any one know what the jumper settings for it should be? Just try it? There are only 2 possiblilties after all... Arno -- For email address: lastname AT tik DOT ee DOT ethz DOT ch GnuPG: ID:1E25338F FP:0C30 5782 9D93 F785 E79C 0296 797F 6B50 1E25 338F "The more corrupt the state, the more numerous the laws" - Tacitus |
#3
|
|||
|
|||
In article ,
says... I have a Quantum 3.8gb hdd which has 3 pins. * * * The hdd came with the Sony Vaio pcv-120. I cant find any info as to where to place the jumper to make the hdd slave. Does any one know what the jumper settings for it should be? Go to Quantum's web site and get the docs: http://www.quantum.com/am/service_su...ds/default.htm -- If there is a no_junk in my address, please REMOVE it before replying! All junk mail senders will be prosecuted to the fullest extent of the law!! http://home.att.net/~andyross |
#4
|
|||
|
|||
Andrew Rossmann wrote says... I have a Quantum 3.8gb hdd which has 3 pins. * * * The hdd came with the Sony Vaio pcv-120. I cant find any info as to where to place the jumper to make the hdd slave. Does any one know what the jumper settings for it should be? Go to Quantum's web site and get the docs: http://www.quantum.com/am/service_su...ds/default.htm Those are just tapes now. The Quantum hard drive operation was flogged to Maxtor and the support stuff is on that site now. |
#5
|
|||
|
|||
Developwebsites wrote in message ... I have a Quantum 3.8gb hdd which has 3 pins. * * * The hdd came with the Sony Vaio pcv-120. I cant find any info as to where to place the jumper to make the hdd slave. Does any one know what the jumper settings for it should be? What is the exact model number ? Quantum's drive operation was bought by Maxtor and thats where the documentation is now. http://maxtor.com/en/support/products/index.htm There were some rather obscure quantum drives that were never that well documented even on the quantum site and didnt make it to the maxtor site. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question on ATX Power Switch Pins and Case Switch? | [email protected] | General | 7 | March 24th 05 07:09 PM |
USP internal pins | Polimedes | General Hardware | 0 | June 29th 04 08:01 PM |
USB Pins...again | Howard | Gigabyte Motherboards | 0 | October 27th 03 04:54 PM |
adding a PS2 port to an old PC | Jan Biel | General | 6 | September 30th 03 03:13 PM |
GA-8KNXP & LianLi case front USB ports | unbekannt | Gigabyte Motherboards | 8 | September 28th 03 10:22 PM |