If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Keep printing from spinning down
I'm not sure what the term is but is is possible to extend the time a
printer is "ready"? Normally a printer will take 8 - 10 seconds to warm up and print a document but once that document is printing it goes very fast. At the end of the job the printer spins down or is not "ready" anymore Is it possible to tweak a driver and keep that printer in a "ready" state, or not spin down? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fan stop spinning... | jazzyb | General | 1 | February 16th 07 11:11 PM |
Fan stop spinning... | jazzyb | General | 0 | February 16th 07 11:07 AM |
Fan stop spinning... | jazzyb | General | 1 | February 13th 07 12:18 AM |
PSU fan no longer spinning | Joe Jorgenson | Homebuilt PC's | 4 | June 11th 06 07:28 PM |
GA-6BXDS rev 1.6 - only one CPU fan spinning | GlassVial | Gigabyte Motherboards | 8 | November 1st 03 03:36 PM |