If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
boot problem .. thank you
thanks all for your help and information ... will try more as time
allows ... |
#2
|
|||
|
|||
I tried using the secondary ide port as Groove suggested ... thought I
would try that before going to the freezer ... machine booted right up Plugged it back into the primary ide port .. booted right up again. Plugged the cd-rw back into the secondary ide port and the maching hung at drive in POST .. like it was doing Tried the hd using the cable from the cd-rw .. booted right up .. Checked the power voltage at the cd-rw plug ... good both ports good, both cables good, I would say that the cd-rw is bad. At least, it only boots up when the cd-rw is disconnected. It is an Acer 8x4x32 Thank you |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Advice on lockup problem | grendel | General | 1 | July 7th 03 05:39 AM |
boot problem | cntrybob | General | 2 | July 5th 03 08:37 PM |
Real hardware problem this time - computer won't boot | Cyde Weys | General | 5 | July 4th 03 02:55 AM |
Computer won't boot with 2000+ Athlon, 2100+ Athlon works just fine | Cyde Weys | General | 4 | July 3rd 03 12:16 PM |
Help! Notebook Won't Boot | °Mike° | General | 1 | June 27th 03 12:13 AM |