|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#21
November 14th 03, 08:03 PM
|
|||
|
|||
"tHatDudeUK" wrote in message ... "jeffc" wrote in message ... Don't lose too much sleep. You'll have a fine system, regardless. Agreed, I upgraded from 133mhz FSB to 200Mhz FSB. It is a little quirkier but to be honest there i little difference. I think my system is mostly limited by hard disk speed so next I'll be going for a stripped raid array... Thanks for that. I used the 2700 ram and it all overclocks ok. Running at 3200 and 200 fsb fine through all tests  )
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PL1600 and 3200 Controller | Adam Raff | Compaq Servers | 1 | November 26th 04 03:30 AM |
| Help OVERCLOCKED barton 3200 at 2500 score | doomer | Overclocking AMD Processors | 3 | September 6th 04 11:13 PM |
| Barton 2500 overlocked to 3200 and Normal 3200 barton which one should i get ? | We Live for the One we Die for the One | Overclocking AMD Processors | 11 | June 14th 04 11:58 PM |
| Advice on components for a new PC | [email protected] | Homebuilt PC's | 7 | October 20th 03 03:36 AM |
| Help with Epson 3200, Please! | Anonymous | Scanners | 2 | October 15th 03 01:54 AM |
Linear Mode
