If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Compaq Smart Array Controller 221 and Linux
Hi everyone,
I'm trying use to this RAID controller under Linux and while it's correctly detected by the cpqarray module, I'm unable to discover attached disks and therefore unable to create any partition on them. I've installed the cpqacuxe (7.0.1) but it reports 'no supported controller found' (which might be right since the aforementioned controller is not is the list of supported hardware but it's the only tool I've found so far). My question is now obvious: has anybody been able to use this controller under Linux and if yes, using which array configuration utility? I'm not even trying to boot from the array, only storing data if I can... And to make things worse, I'm not using the board in a Compaq server. Thanks in advance. -- Frédéric |
Thread Tools | |
Display Modes | |
|
|