If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
x800xl and Far Cry, disasterous!
....WHAT - A - DISASTER!!! My tech specs: WinXP home SP2 Abit IS7 mobo P4c HT 2.60ghz 1 gb Kingston Dual channel PC3200/DDR400 Value RAM Maxtor 80gb 7200rpm/8mb on a seralell (Siralell?) adapter Maxtor 40gb 7200/2MB storage disc New Pioneer DVD drive Sony burner x800xl AGP made by ATI, 256/256bit 400gpu / 980RAM... -- Product ID: 100-435508 -- using Omega 5.9 drivers only, thus far On first attempt, using the fully upgraded Far Cry 1.33, the computer shuts down fully, power all the way off, taking much MB electricity with it, as takes 3 minutes to be able to turn it on again. This happens time after time and it played fine, if a little slow, using the old GF4 Ti4600. by Chaintech. After the second occurance I increased the AGP voltage by a half a point as well as the same for the P4 CPU... then I was able to start the game and play a while at increased graphics levels and some types shadows for smaller objects were not black, but green and yellow. When driving a vehicle it froze after a while, then it was all over for good, and same story. I must have worked with this for 5 hours, and gone through 25 restarts... Anyone know what can be done before I grab a replacement RMA? TIA all, -- Giant_Alex cravdraa_at-yahoo_dot-com |
Thread Tools | |
Display Modes | |
|
|