If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Easy switch between VGA and DVI (or both)
Is there a small utility to make it easy to switch between VGA - DVI
- BOTH (like on laptops between build-in and external). I have my monitor on VGA and my TV on DVI, and would like an easy switch (could leave both on but card gets hotter). -- Lars-Erik - http://www.osterud.name - ICQ 7297605 WinXP, Asus P4PE, 2.53GHz, 1GB, MSI 7600GS, SB-Live |
#2
|
|||
|
|||
Easy switch between VGA and DVI (or both)
"Lars-Erik Østerud" .@. wrote in message ... Is there a small utility to make it easy to switch between VGA - DVI - BOTH (like on laptops between build-in and external). I have my monitor on VGA and my TV on DVI, and would like an easy switch (could leave both on but card gets hotter). -- Lars-Erik - http://www.osterud.name - ICQ 7297605 WinXP, Asus P4PE, 2.53GHz, 1GB, MSI 7600GS, SB-Live Hi Lars, In the Nvidia control panel click "Display Set up multiple displays" in the left task tree then click the "Select the display you would like to use" drop down menu and select the monitor you want to use. Hope this helps Andy |
#3
|
|||
|
|||
Easy switch between VGA and DVI (or both)
In the Nvidia control panel click "Display Set up multiple displays" in
the left task tree then click the "Select the display you would like to use" drop down menu and select the monitor you want to use. I was looking for a hot-key (or another easy way). Found that if I enable "nView" I can add a hot key to "switch to next display", and when in "single display" mode that will switch between the VGA and DVI output (switching between my monitor and my TV that is :-) But I found no easy way to do as on laptops (yet). I can now switch: monitor - tv - monitor - tv ... But not: monitor - tv - BOTH - monitor - tv ... (that requires that I change to "clone" mode manually) So what I want is some way to switch like this: - Single display: VGA - Single display: DVI - Clone: VGA + DVI - Single display: VGA - ..... With one key-stroke -- Lars-Erik - http://www.osterud.name - ICQ 7297605 WinXP, Asus P4PE, 2.53GHz, 1GB, MSI 7600GS, SB-Live |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EASY EASY MONEY PLEASE GET IT.. | [email protected] | Homebuilt PC's | 0 | March 21st 08 07:53 PM |
Using a standard switch as a momentary switch | [email protected] | Homebuilt PC's | 3 | April 27th 07 12:56 AM |
Question on ATX Power Switch Pins and Case Switch? | [email protected] | General | 7 | March 24th 05 07:09 PM |
Connector between power switch, reset switch, LEDs, speaker and Micro ATX mobo | Clive Long,UK | Homebuilt PC's | 2 | February 22nd 04 11:01 PM |
Wanted Monitor Switch to switch between 3 PCs recommend any ? | We Live For The One We Die For The One | Homebuilt PC's | 4 | November 30th 03 05:27 PM |