If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
AP400 fan connector..help
I'm trying to quieten down an old Compaq ap400. I've found a much
quieter fan to fit into it but the new one only has two wires from it and the old noisy one has three. The connector on the motherboard has four prongs with a gap, something like this: | | | | The connector wires a black (gap) red (gap) yellow Now, can I just connect the black and red wires, or is the yellow wire a sensor or something? I was also considering wiring it up to a molex and reducing it to a 7v instead of a 12v, making it even quieter. Any help would be appreciated, thanks. Andy |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help required for ap400 usb drivers | Kevin Childers | Compaq Computers | 2 | February 20th 05 11:13 AM |
Help required for ap400 usb drivers | kevin | Compaq Computers | 0 | February 18th 05 07:45 PM |
Help required for ap400 usb drivers | kevin | Compaq Servers | 0 | February 18th 05 07:45 PM |
AP400 | Dave | Compaq Computers | 0 | December 6th 04 07:00 PM |
Compaq AP400 problems | Michael Calwell | Compaq Computers | 1 | November 13th 04 11:10 PM |