|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 5th 05, 01:39 AM
|
|||
|
|||
After Burning with Nero, CD drive won't work until reboot
Anyone else seen this? Using Windows XP SP2, LiteOn LTR-52327S CDR and
LiteOn SOHW-832S DVD-RW with all latest updates and firmware. Once the burned CD or DVD is done, that drive will be recognized correctly, but the disk in the drive will not load or be recognized until after rebooting. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about transfer speeds between HDs, and DMA mode | ZigZag Master | Storage (alternative) | 25 | July 25th 04 09:56 PM |
| Is my hard drive the source of my CD burning woes? | Jonathan King | General | 4 | March 19th 04 12:06 AM |
| Windows XP fails to boot after Drive Image 7 restore | Milleniumaire | Storage (alternative) | 11 | February 28th 04 08:26 PM |
| How to install 2nd HDD with Partition Magic 6.0 partitions under Windows ME? | Phred | Dell Computers | 13 | February 18th 04 08:45 AM |
Linear Mode
