If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
setting block mode on IBM LTO
I need some help on how I can check/set the block mode (fixed or
variable) on an IBM 3582 LTO2 fibre channel tape library. The unit is posting errors mentioning that the drive is set to fixed mode whilst doing snap backups directly from a NetApp filer. I have more error info if needed. Any help greatly appreciated as IBM are like George Bush, answering every question but the ones I ask! Cheers, TJD. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Newbie: OC Advice: AMDXP2200 CPU | Donald Bock | Overclocking AMD Processors | 2 | March 12th 05 12:14 AM |
out of range error in safe mode only | Bruce A. Evans | Ati Videocards | 2 | September 1st 04 05:11 PM |
Which drive mode (LBA or Normal) for a laptop HDD? | Knack | Storage (alternative) | 7 | October 13th 03 10:04 PM |
Power Surge | David LeBrun | General | 44 | September 12th 03 02:35 AM |
Slow framerates: TNT2 M64 - Seems to be in PCI mode | noise | Nvidia Videocards | 6 | July 18th 03 09:30 PM |