If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Another reason to get "TV Failed to Initialize, Check Drivers" error with MMC9.16 and Cat7.1
Just found a new, for me, way to get the "TV Failed to Initialize, Check
Drivers" error with MMC9.16 and Cat7.1. Tried reinstalling the drivers several times and repair install of MMC twice without effect. Trying to get video of the Daytona race to my network media device, set the path for capture to the DNAS drive(G in the player. Later, started getting the error. Took quite awhile to remember the path change. When I turned the DNAS back on DTV ran OK. Had to run the DTV initialization wizard to get the path set back to D:. Now it's back to normal. In previous version(before 9.13) this would have just disabled TVoD on the HDTV Wonder. IOW a path error shows up as a device driver error. If it wasn't possible to recreate the path a registry hack would probably be needed or clean and reinstall of drivers/MMC. BTW I have an AIW, the HDTV Wonder and using XP. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Canon MP130 "Check Ink Tank" Error | Baphomet | Printers | 4 | February 1st 07 04:42 PM |
"Memory failed configuration" error | [email protected] | General | 3 | December 1st 06 06:18 PM |
Nero "Failed Verification" Burn Error. Why?? | Razor | Cdr | 0 | July 18th 06 03:10 PM |
Samsung ML-2150 (2152W) (1) suddenly prints all pages "almost" blank and (2) error message "HSync Engine Error" , not in user manual | Lady Margaret Thatcher | Printers | 5 | May 4th 06 04:51 AM |
Solution to HP Error "Remove and Check Cartridges" | [email protected] | Printers | 1 | February 19th 06 04:26 PM |