If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
starting problem with 5500r 6/200
I have problems with my 5500r 4*200 PPro.
What I think what happend: A week ago I rebooted the 5500r but left in the POST with "Press F1 to continue". A day or so later it was automaticly powered off! And I think it said something like "system powered off" on the diag LCD. Then I had problems switching it back on, so I pulled out some cards and boards and reseated them, but to no avail. Later I found out that is was a bad case switch which worked only when pressed real hard. After shortening the case switches it powered up, but no picture, no diag screen on the front LCD, nothing. I see that the internal LEDs near the connector panel on the back do some blinking, but I have no documentation about what they mean. The two installed VRMs are "green" on the cpu board too. Anything else I might try? -- I am root. If you see me laughing, you better have a backup. |
#2
|
|||
|
|||
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
GA7N400 Pro (not Pro2) problem - advice requested | Eddie B. | Gigabyte Motherboards | 4 | January 8th 05 02:17 PM |
Help needed with unidentified problem | ^MisterJingo^ | General | 3 | November 23rd 04 05:45 AM |
Mouse Problem | Jeff | Homebuilt PC's | 0 | October 1st 04 06:44 AM |
This problem has baffled everyone... | Nick G | General | 46 | May 22nd 04 04:01 AM |
help with refresh problem please | Michelle | Ati Videocards | 15 | November 27th 03 03:01 AM |