If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Learned a hard lesson a few days ago
Just built a new PC:
p43.2EGhz p4c800-E Deluxe 1GB DDR 400 ram Enermax 430watt PSU FDD Sony DVD-RW etc... I built it and everything went fairly well. In my old PC I had a Western Digital 80GB HDD w/8MB cache as the master and a WD160GB HDD as slave/data storage. I built the new PC, added the old master drive, reformatted, installed Windows XP Pro OS, and all the software. Then, after I was all done, I decided to put my 160GB storage drive in. I had updated XP Pro to SP1, so it supported it, as it did on the old PC. When I put it in the new PC I also did a reformat from the WD boot disk and continued to boot up the os. Windows XP recognized the drive and assigned a letter, BUT it could not open the drive. SMART diagnostics from within Windows said there was a failure. Ok, not the first HDD I've had fail. So I removed it and rebooted. On the new boot I get an error message saying Windows can not authenticate this version. This message appears at the login screen. I click ok (that's the only option). NOTHING HAPPENS.... ok...so I try to rebooot in safe mode and see what's the problem, and if necessary do a system restore. In safe mode I get the same message. I can't get into Windows at all. Call Microsoft...after about two hours on the phone the guy finally tells me it can't be fixed. I told him I HAD to have the data on the good master drive. So he tells me how to copy some files from the XP CD into my c:\windows\system32 drive from the DOS prompt on the XP CD. Then I'm finally able to get Windows to boot. He gives me a new activation code since it recognizes this as a new install. Then I can get to my data to transfer it to another drive, but all my programs are zapped, and I didn't have a registry backup. So I transfer the data to another old HDD and then have to reinstall everything. The problem was that since the new drive I was installing failed, Windows hardware manager did not get a chance to recognize it, and thought basically that the HDD had been moved to a new PC. Long story short....Windows activation system sucks. Keep this in mind if you think you'll try to install ANY hardware that MIGHT be bad. Windows monitors hardware through its activation system to prevent a licensed copy from being run on multiple PC's. If your hardware fails and you try to install it, Windows may very well fail as well. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ATA100 hard drive not recognized when PS/2 mouse is not attached | S. Lipson | Homebuilt PC's | 2 | July 27th 04 09:55 PM |
Boot problem | *Vanguard* | General | 8 | February 29th 04 06:53 AM |
Happy Birthday America | SST | Overclocking | 333 | November 27th 03 07:54 PM |
Happy Birthday America | SST | Overclocking AMD Processors | 326 | November 27th 03 07:54 PM |
New HD in Dell Dimension 4300? | Leif K-Brooks | General | 2 | July 3rd 03 05:23 AM |