If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
DeskPro 6000 Configuring HD
I'm trying to configure a DeskPro 6000 (Pentium Pro 200) but can't
seem to get it to create the Diagnostic Partition. I boot with the Setup disks (1 & 2) and it sees the hard drive fine. I do a Save and Exit and then boot with the Diagnostic disk to Create a Diagnostic Partition and all i get is an error saying the Disk is Locked or there's a problem with hard drive. Tried 2 different drives, a 1.0 GB and a 1.2 GB drive... same result. What am i doing wrong? TIA |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem adding memory Compaq Deskpro EN | patfada | Homebuilt PC's | 1 | February 8th 05 09:56 AM |
Need help configuring raid | ftran999 | Asus Motherboards | 5 | November 17th 04 03:58 AM |
Layout Power supply Deskpro EN | Bruno Keller | General | 8 | February 6th 04 10:37 AM |
Compaq deskpro en upgrade | jay | Compaq Computers | 1 | July 21st 03 05:41 PM |
HELP! driver problem for Compaq Deskpro EP/SB C333 | mm | Compaq Computers | 2 | June 29th 03 09:58 PM |