If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Determining HBA model
I am trying to qualify an Emulex HBA this was installed in a Dell
Power Edge 2650 server, but not purchased from Dell. The server is running Windows 2000 SP4, I am trying to find out what the actual model of the HBA is installed to verify interoperability with NetApp storage. I have been given the following information on the HBA that looks like it is perhaps in the Windows registry: "Emulex LP98 PCI\VEN_10DF&DEV_F980&SUBSYS_F98010DF REV_01\3&172E68DD&0&08" Does anyone have an idea how this information can be tied to an actual HBA model (ie. LP9002, LP9?????) TIA for any information. Tom |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Why 2200+ & 2800+ in both model 8 & model 10 Sempron? | [email protected] | General | 3 | September 27th 04 05:40 AM |
Why 2200+ & 2800+ in both model 8 & model 10 Sempron? | [email protected] | Overclocking AMD Processors | 0 | September 14th 04 12:46 AM |
Why 2200+ & 2800+ in both model 8 & model 10 Sempron? | [email protected] | Homebuilt PC's | 0 | September 14th 04 12:46 AM |
Why 2200+ & 2800+ in both model 8 & model 10 Sempron? | [email protected] | General | 0 | September 14th 04 12:46 AM |