If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Display pausing
On Thu, 26 Jun 2003 12:08:43 +0100, "-" wrote:
My new Creative Blaster 4 MX420 PCI (64mb) seems to be causing my screen to lock up for upto 5 seconds every so often. Is this an over-heating issue or something else? My onboard TNT never had this problem. Is it something that I have to get used to because the PCI bus is slower than the AGP I was used to before? I think 5 seconds is unreasonable - the rest of my system is reasonably decent (512mb RAM, 1.3Ghz processor) and so I'm convinced its just the new card... That kind of pause, then being able to resume using the system, is often the result of IDE read/write problems... check your cables and drives in case you accidentally disturbed something during the video card install. Dave |
#2
|
|||
|
|||
Hmm, seemed to have pinpointed it down to the Nview software that comes with
this card. Disabling Nview sorts it out (or seems to have so far). |
Thread Tools | |
Display Modes | |
|
|