If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Can't boot from Yamaha CRW4416S
If you're talking about booting to an SCSI drive, you have to have "boot
from SCSI" enabled in your BIOS, and it have to be before the HD in the boot sequence. "Fishface" ? wrote in message ... Does anyone have this drive, and can you boot from it? I posted this to the SCSI group, but got no response: I put the Yamaha CRW4416S and Tekram DC-390F together with a Quantum Viking II 9.1GB drive and tried to install the OS from CD. It won't boot from the CD. "Boot from CD-ROM" is enabled in the adapter settings. Both devices are recognized in the bios scan. The HD still has an old installation of XP Home that wasn't activated and when booted into safe mode (the only way to get in) it is able to read the CD. I had these parts together in my old BX board, and am almost certain I was able to boot from the CD. All firmware is current, 3.23 for the Tekram and 1.0j on the Yamaha. The Yamaha spins-up, as if examining the disk to see if it is bootable, but it proceeds to boot from the HD. I also tried a bootable Symantec disk without success. Synchronous and wide negotiation are disabled as per Yamaha 'site instructions. I'm stumped. Any ideas? I guess I'll have to scrounge-up a floppy drive from somewhere... Thanks for any help! |
#2
|
|||
|
|||
Dan G wrote:
If you're talking about booting to an SCSI drive, you have to have "boot from SCSI" enabled in your BIOS, and it have to be before the HD in the boot sequence. There are no IDE devices at all, so that's not the problem. It boots from the SCSI HD regardless of the SCSI adapter bios setting to "boot from CD-ROM." |
#3
|
|||
|
|||
Some motherboards/BIOS cannot boot from more than one SCSI device, they pick
the first one they see. Still suggest you look at your BIOS and see what choices you have. "Fishface" ? wrote in message ... Dan G wrote: If you're talking about booting to an SCSI drive, you have to have "boot from SCSI" enabled in your BIOS, and it have to be before the HD in the boot sequence. There are no IDE devices at all, so that's not the problem. It boots from the SCSI HD regardless of the SCSI adapter bios setting to "boot from CD-ROM." |
#4
|
|||
|
|||
Fishface wrote: Dan G wrote: If you're talking about booting to an SCSI drive, you have to have "boot from SCSI" enabled in your BIOS, and it have to be before the HD in the boot sequence. There are no IDE devices at all, so that's not the problem. It boots from the SCSI HD regardless of the SCSI adapter bios setting to "boot from CD-ROM." If there is an utility for the SCSI host utility, run it and set it to boot from the SCSI ID that is for the Yamaha drive. The otherwise alternative would be to assign the CDROM a target ID of 0 and the HD an unused ID that is greater than 0, i.e., swap their ID numbers. |
#5
|
|||
|
|||
GHalleck wrote:
If there is an utility for the SCSI host utility, run it and set it to boot from the SCSI ID that is for the Yamaha drive. Yep, tried that. The otherwise alternative would be to assign the CDROM a target ID of 0 and the HD an unused ID that is greater than 0, i.e., swap their ID numbers. I tried that too. I tried putting it on the 50 pin cable alone and terminating it. It just will not boot. I reseated the card and checked the pins. I have even considered flashing to prior firmware revisions but I am just getting tired of messing with it... |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Can't boot from CD | Zotin Khuma | General | 6 | November 16th 04 10:18 PM |
BX6 rev2 boot problem | Ian | Abit Motherboards | 5 | October 8th 04 09:52 PM |
NF7 Boot SATA | systrade | Abit Motherboards | 0 | September 29th 04 10:47 AM |
Boot problem with Promise SATA Fasttrack S150TX2 Plus | Wizard | General | 0 | September 13th 04 06:54 PM |
Hard drive that boots elsewhere refuses to boot in this machine | Simon O'Connor | General | 9 | July 22nd 03 06:34 AM |