If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
CPU fsb/dram ratio's
Hi all,
I have just installed an ABIT NF-7S rev 2.0. In the BIOS settings there is an option of CPU fsb/dram ratio's which offers a selction of dividers. If I want the fsb to run at the same speed as the memory bus what is the correct divider to use? Cheers -----= Posted via Newsfeeds.Com, Uncensored Usenet News =----- http://www.newsfeeds.com - The #1 Newsgroup Service in the World! -----== Over 100,000 Newsgroups - 19 Different Servers! =----- |
#2
|
|||
|
|||
"sacrum" wrote in message ... Hi all, I have just installed an ABIT NF-7S rev 2.0. In the BIOS settings there is an option of CPU fsb/dram ratio's which offers a selction of dividers. If I want the fsb to run at the same speed as the memory bus what is the correct divider to use? Cheers -----= Posted via Newsfeeds.Com, Uncensored Usenet News =----- http://www.newsfeeds.com - The #1 Newsgroup Service in the World! -----== Over 100,000 Newsgroups - 19 Different Servers! =----- Either set it to "Auto" or any setting with a 1 to 1 ratio. (i. e. 3/3, 4/4, 5/5, 6/6, etc) "Auto" is probably best. John |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Overclocking: ratios and dividers, blah, etc. | Bryan L | Overclocking | 6 | October 31st 03 04:28 PM |