|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 2nd 03, 05:41 PM
|
|||
|
|||
Any Advice?? - Intel D865PERL - 2 SATA drives - Cannot establish RAID 0
Hi,
I have tried Configuring the RAID 0 volumes (Cntl-i) prior to installing OS (WinXP Pro) about 4 times. I F6 the Intel App Accel drivers during OS install. Then, tried twice to Migrate to RAID 0 after establishing the system as RAID-Ready. Everything acknowledges success. But, when I try to boot-up, it says: Disk read error occurred Press Ctrl+Alt+Del to restart. I have no problem if drives are separate and not in RAID config. System: P4 3.0 G 800Mhz FSB 2 Maxtor SATA-150 160 Gb drives Intel BIOS latest p12 from site. All drivers used are latest downloaded from Intel site. Thanks (TIA) for any input 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Intel 865Perl - More than 2 SATA drives | William G. Anderson | Homebuilt PC's | 0 | December 26th 04 06:03 PM |
| Adding SATA drive to 8KNXP | Bob Davis | Gigabyte Motherboards | 10 | January 23rd 04 09:25 AM |
| GA-8KNXP, how to configure BIOS for SATA? | John Ward | Gigabyte Motherboards | 20 | October 6th 03 07:42 AM |
| Hard drives and Intel D875PBZ | Aloke Prasad | Intel | 2 | September 1st 03 04:21 AM |
| Disappearing SATA drives on GA-8KNXP ? | Ackk | Gigabyte Motherboards | 1 | July 30th 03 06:56 AM |
Linear Mode
