|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 27th 04, 05:06 AM
|
|||
|
|||
re External USB multiport
I just installed a new external USB multiport to my PC. Now whenever I boot
up, the PC cannot read my hard drive. So I have to disconnect th mulitport first, boot up and then reconnect. Any ideas? Thanks! 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| On the brink of madness... | I.C. Koets | General | 18 | January 31st 05 10:49 PM |
| RAID boot failure when external drive is connected | Peter Strong | General Hardware | 0 | September 7th 04 01:31 PM |
| Updrade PC | Guy Smith | General | 22 | August 15th 04 01:57 AM |
| Maxtor External 3000LS External Hard Drive Installation | Sam Hollenbeck | General Hardware | 1 | February 7th 04 02:50 PM |
Linear Mode
