If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Precision 670 case rattles (badly)
Ever since buying the 670 workstation, I've been hunting down cabinet rattles. For a while I was shoving plastic shims in the case covers but that wasn't solving the problem. It was a kludge. Instead got some 1/8" x 3/8" wide adhesive-backed from rubber tape from Ace Hardware. Have been cutting and sticking pieces of foam under the covers and seams for months, but I swear that EVERY case cover is loose-fitting and needs some kind of rubber gasket. The question is.. how does one remove the charcoal-colored plastic panels from the chassis without breaking off the tabs? I have one more panel to silence, and that is the bottom plate (or back side panel when it's standing.) Damn!! if they're going to fit so loosely, then Dell ought to make it easier to pop-off the covers!! -ed |
#2
|
|||
|
|||
Precision 670 case rattles (badly)
Hi!
It sounds to me like someone already broke (or at least abused) your system's case. The plastic cases are both of creaky and shifty when handled, but when sitting still (whether running or not), I haven't noticed them making any creaking noises. Nor have I noticed any other noises besides what computers typically make. William |
#3
|
|||
|
|||
Precision 670 case rattles (badly)
On Fri, 29 Jan 2010 06:55:11 -0800 (PST), "William R. Walsh"
brought the following to our attention: Hi! It sounds to me like someone already broke (or at least abused) your system's case. The plastic cases are both of creaky and shifty when handled, but when sitting still (whether running or not), I haven't noticed them making any creaking noises. Nor have I noticed any other noises besides what computers typically make. William You could very well be right. I actually broke one of the tabs on the rear-most cover (above the power supply - beside the backplane) trying to detach it. That's because there were no drawings show how the covers are held on, or come off. Now there is even an internal rattle coming out of the TOP intake vent, which is probably one of the CPU fan shrouds. There are only about two more rattles to fix. Eight or ten other panels and seams are already damped with the 1/8" think foam strips!! ) -G |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HD rattles when shaken | Franc Zabkar | Storage (alternative) | 9 | September 15th 09 07:38 AM |
Dell Precision 210...Can't get the plastic case OFF | fadeToblack | Dell Computers | 7 | January 9th 08 04:25 AM |
650 motherboard in 530 precision case? | dipa | Dell Computers | 0 | January 29th 07 06:16 AM |
Badly need help | penguin_10404 | General | 3 | November 20th 05 07:29 PM |
Need Help badly | ma | Ati Videocards | 14 | October 7th 03 05:37 AM |