|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 24th 03, 03:56 AM
|
|||
|
|||
Multiplier ratio setting for Xp2400?
I just bought a JETWAY v266B mobo. The Jetway website says that it will
support an AMD 2400 (with the latest BIOS ) and using a multiplier of 15 ( FSB of 133/266). OK , so far. Trouble is that the manual included with the mobo and the manual at the website only shows the switch settings for a multiplier ratio up to 12.5. Help!! Barry 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A7V266 + 2600+ | Zdenek Sojka | General | 9 | November 7th 04 12:52 PM |
| Setting up webserver | Micky | General | 4 | February 11th 04 12:35 AM |
| screen saver vs turn off monitor setting for LCD monitor | dave | General | 4 | December 7th 03 08:23 PM |
| nForce MCP NIC setting? | Alceryes | General | 0 | November 30th 03 02:11 AM |
| Multiplier question, bios or hardware... ? | Bougon | General | 1 | June 24th 03 12:58 AM |
Linear Mode
