If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
HD IDE Cable - New XPS Gen 3
Quick question... I just purchased a new XPS Gen 3 (3.6) with a single 74GB
10,000 RPM HD. I did not get a second drive since I already have some large drives here that I planned to add. Problem is since I only ordered the computer with one drive, the primary IDE cable for the HD only has a single connector. Is this typical? Can I just pick up a standard two-connector IDE cable in order to add the second drive? TIA for your suggestions! Doug |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Digital Cable setup? | Shelley | Ati Videocards | 2 | April 3rd 04 06:05 AM |
Split Cable Modem Line For TV Tuner? | *Vanguard* | General | 3 | November 23rd 03 11:14 PM |
cutting psu wires | Pen | General | 4 | July 27th 03 07:49 PM |
No partition data when ATA-100 cable used. | DS | Homebuilt PC's | 5 | July 8th 03 08:01 AM |
2nd HD install question cable orientation | GarySport | Dell Computers | 5 | July 5th 03 03:48 AM |