|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 11th 06, 06:26 PM
posted to alt.comp.hardware.pc-homebuilt
|
|||
|
|||
Raid1 with K8T800, Via Chipset and Ide Drives
I had a scare last week when my primary HD wasn't seen in my Bios. I
was lucky, a cable had worked loose. I would like to complete a Raid1 array using a mobo K8T800 with a Via chipset, two 200 Gig Seagate IDE ultra ATA Drives, and a 400 gig IDE drive as a slave. I am considering purchasing a HighPoint RocketRAID100 PCI IDE Controller Card RAID 0,1,0+1 JBOD. Can I Raid1 the two Seagates and keep the third drive as a slave with the already mentioned components? TIA 
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
