|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 5th 03, 10:29 PM
|
|||
|
|||
My P4 2.53 @ 3.06 w/ pc2100 is that all ?
Could I expect to get more out of my P4 with PC3200? Right now the FSB is at 167,
Idle Temp 24c load temp 38c 
|
|
#2
October 6th 03, 09:28 AM
|
|||
|
|||
|
it all comes down to your mb: i can't get a P4B 2,66 to go higher than 3,0
(150fsb) on my msi655max. just changing the memory doesn't make your processor go any higher: you can (propably) adjust the memory bus speed lower than the fsb if you feel the need to see your processor/mb limits. btw: nice temps. i take it you haven't upped the voltage on the processor? -pete kirjoitti viestissä m... Could I expect to get more out of my P4 with PC3200? Right now the FSB is at 167, Idle Temp 24c load temp 38c
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PC2100 w/ 333 MHz Barton and Soyo KT600 Ultra PE | anybody | General | 4 | September 18th 04 03:52 PM |
| Dumb thing and mixing PC2100 and PC2700 DDR RAM [long] | David W.E. Roberts | General | 1 | August 6th 04 12:18 PM |
| Dumb thing - and mixing memory PC2100 and PC2700 - and WHAT??? | David W.E. Roberts | General | 3 | August 5th 04 02:39 PM |
| Overclocking M7NCD Pro with Barton CPU and PC2100? | Matt | Overclocking | 5 | September 12th 03 11:00 PM |
| P4 3.06 GHz Temps at 50C idle!!! | Justin Horne | Overclocking | 6 | August 24th 03 08:59 PM |
Linear Mode
